Re: Tilt/Trim
 

Your call but if it was me i wouldn't replace anything until i went thru the troubleshoot procedure. More often than not, there is nothing wrong with the switch (unless its been physically broken) and its usually a wet/corroded connection at one of the two solenoids or pump that causes the problem.

Re: Tilt/Trim
 

the switch sticks in the up or down position. it doesn't "bounce" back like it should.

Tilt/Trim
 

So I diagnosed the trim/tilt issue. It seems that the trim pump is not working. My uncle, a master electrician and shade tree mechanic, came over and even with the lift cylinder unhooked we could not get any of the hydraulic fluid out. All the electrical is good and is testing the way it should. What's a good place to get a new unit?

Re: Tilt/Trim
 

You have a Alpha or a Bravo Drive?
Looks like either way , part # is 865380A13.
Merc price is around 700.00. OUCH!
Look on Ebay.
Might try part # 14336A8
Or get a used one.

Tilt/Trim
 

Alpha one gen ii. I found one for like $300 but I didn't have part # on me to verify

Tilt/Trim
 

Looks like its not the right one. I will have to do some research. The one I found for like $700 is saying I have to buy adapters for the hydraulic lines because the one I'm replacing is a 1996.

Re: Tilt/Trim
 

Where are you located? A good auto electric place should be able to rebuild those motors....my neighbor had his rebuilt like new for just a shade over $100

Tilt/Trim
 

Senoia, ga. Home of the walking dead.

Tilt/Trim
 

Can anyone tell me if this is the right part?

http://www.iboats.com/Mercury-Marine-Mercruiser-Inboard-OEM-Replacement-Power-Tilt-and-Trim-Motor-6275-Complete-Arco/dm/cart_id.277230033--session_id.310367865--view_id.351013

Tilt/Trim
 

Or is this right?

http://www.amazon.com/gp/aw/d/B00AN8T064/ref=mp_s_a_1_fkmr0_1?qid=1377624904&sr=8-1-fkmr0&pi=SL75