[dominick]

Sorry I'm a new member/owner of a 2001 Shabah z250 with the Bravo III. I had it out today and it was fine until I tried to shift into gear and felt a slight clunk then it wouldn't move.I shift it to drive or reverse I can give it throttle but it won't move.I can turn the prop left to right and the prop spins freely by hand. Any advise?

[Motoxxx43]

Hey Dominick, I recently bought a 250. I inquired with a few z250 owners. Just curious where you picked yours up from?

Back to your question- did it work prior to buying it?
Is there enough drive fluid?
What else do you notice about the drive, movement, sounds, damage?

[Oregondunes]

So it wont go in gear in either forward or reverse ? I could guess and offer this:

1. Either your shifter cable is out of adjustment and not throwing far enough to engage the tranny.
2. Your drive shaft is broke (been there/done that)
3. The clutch went out inside the upper unit
4. The splines are so warn in the coupler the drive shaft is spinning in it.