[nelson]

hello,im a new boat owner.I purchased a 94 mariah talary with a 350 mag and an alpha 1 gen 2 lower unit. This boat sat in a field for 11 years. On my first shakedown run found out carb needed rebuild and the gimble baring went out just putting around the lake.The marina I took it to found that the gimble barring housing needed replaced due to a 2 inch chip in the flange that the below attached to.1700.00 part and 800.00 labor.But I found the housing for 250.00 at a local boat junk yard. Well after all that I had a nice boat,rented a slip at mores lake,5 min. from my house in Noblesville IN and have been taking the kids tubing wake boarding ect.for about four weeks. then couple days ago I started losing drive fluid. took it to the marina, they said the upper seals are bad and the yolk needs replaced to the tune of around 500.00. Oh well,thats boating,ching ching. well Im looking forward to getting back on the lake. Thats my story. nice meeting you all.Can anyone tell me where I can buy some mariah emblems,the ones that go on the vinyl inside the boat?

[Z 202]

Hey Nelson, welcome the the club!

BOAT = break out another thousand...

As for the missing emblems, check out this sticky thread in the Mariah Parts and Collectible sub-forum: Original Mariah Decals.