This should be a cheap fix
 

It's only a little split ;)

http://i681.photobucket.com/albums/v...430_190328.jpg

Re: This should be a cheap fix
 

Hmmm!
The list of parts seems to be bigger than I'd first imagined :eek_animated:

http://i681.photobucket.com/albums/v...430_185423.jpg

Re: This should be a cheap fix
 

Seems like it always works out that way Andy.:eek_animated:
I know it does when I figure it's a simple/cheap job.:rolling_laugh::rolling_laugh:

Re: This should be a cheap fix
 

What are you up to there Andy?? Is that for the thru hull exhaust??

Sent from my HTC0P3P7 using Tapatalk

Re: This should be a cheap fix
 

Pushing my luck.......Too far again!:rolling_laugh:

I knew I needed new manifolds/risers and had them on order, but got the itch the other weekend and went out with some friends :rolleyes:

http://i681.photobucket.com/albums/v...ril204_640.jpg

When I de-winterised the motor the rusty water and Bits of rust that got blown out was bad!!! :shakehead:



Everything was going fine until I went for a high speed run. The rusty manifolds blocked the risers and the increase in water pressure split the cooling pipe. The reduced water flow in the exhaust cooked the rubbers!:shakehead:

All very dramatic at the time :yes_grin:

They will certainly help :yes_grin:
But not planning on fitting them ATM.
I want to have the time to do it properly, and not rush the job......
Which at this time of year will probably happen! :rolleyes:

Re: This should be a cheap fix
 

That hose can be saved with duck tape! Much cheaper... :rolling_laugh: