The Mariah Owners Club
Page 3 of 3 1 2 3
Show 40 post(s) from this thread on one page

The Mariah Owners Club (http://www.mariahownersclub.com/forum/)
-   Original Mariah Talk (http://www.mariahownersclub.com/forum/original-mariah-talk/)
-   -   drive unit u-joint rust? (http://www.mariahownersclub.com/forum/original-mariah-talk/9032-drive-unit-u-joint-rust.html)

Hudson River Steve 03-16-2018 11:37 AM
Re: drive unit u-joint rust?
 
Quote:
Originally Posted by sabujoseph (Post 64302)
hi
i have removed out drive alpha one of 1993 mariah inboard boat for replacing gimbal bearing and seal assembly,boots etc.
removed old bearing and put back new bearing
do i need any special tool to align spline shaft to bore.
i need advice on it. any link to see that please.
thanks
As long as you seated the new gimbal bearing properly there should be no need for further alignment. It is pretty straight forward.

Sent from my XT1254 using Tapatalk


All times are GMT. The time now is 09:31 PM.
Page 3 of 3 1 2 3
Show 40 post(s) from this thread on one page