Faria depth gauge
 

Can anyone tell me how to troubleshoot the Faria depth gauge on my 2001 192 Shabah. The gauge comes on but just reads UN I guess for unknown. I looked in the engine compartment and found the transducer it seems to be hooked up fine.

Re: Faria depth gauge
 

Check to see if the transducer has come loose in its mount. If so it wont read properly even if still wired correctly.

Re: Faria depth gauge
 

Checked that it is securely hooked to mount. Anything else I can check?

Re: Faria depth gauge
 

Re: Faria depth gauge
 

Ok thank you. Will give them a try.

Re: Faria depth gauge
 

I have the exact same problem. If I push "mode" it will go from shallowest depth, to deepest, to "UN", and that's it. I'm trying to figure it out also. If I do I'll let you know and you do the same.

Thanks.

2001 Z-202 Shabah

Re: Faria depth gauge
 

Ok sounds good. I have't contacted Faria yet been at the lake too much. But when I get it fixed I will post any resolution here.

Re: Faria depth gauge
 

Ok so I think I know what the problem is with my depth finder, the transducer is mounted on a ring that is about an inch tall so there is air space between the bottom of it and the boat, that air space has to be filled with mineral oil because the signal will not pass through air. Mine was dry as a bone! Hope this helps.