Tempurature sensor question
 

Hi, I didnt want to hijack the other thread about the sensor wire so here is a new one. I replaced the thermostat housing on my 92 350 mag. The two holes for the two tempurature sending units are not in the same place. The newer style housings have the port side sensor toward the back of the housing. It ont fit now as it hits the intake manifold. What can I do to make sure both of these sending units work. Is there a sending unit that both of these wires could hook to, Also I see a plg in the intake maifold to the the side of the housing, can this be used to install the sensor. Thanks