talari 216 fuel fill
 

Would anybody know the correct diameter of the pipe section of a fuel cap assembly. It's either 1.5'' or 2''.
i want to remove the old cap and its' integrated short pipe and fit a new filler cap assembly. THis has to fit into the rubber pipe below which leads to the tank. i need to be able to match up the pipe from the filler assembly with the rubber tube.

regards

fuel filler for talari 216
 

looking for suitable s. steel or chrome replacement

Re: fuel filler for talari 216
 

Did you have a look thru our Original Parts & Vendors List?

Re: fuel filler for talari 216
 

yes i did - boats and boating said the original attwood is no longer available and suggested Attwood Gas Fill, 1.5 Inch Stainless Neck, Flip Open Cap. this however is an angled assembly with a breather. i am pretty sure the existing one is straight down with no breather. its almost impossible to see and i will have
to cut a large hole in the upvc to get my hands through to unsccrew - i believe it is secured with a jubilee clip. This must be one of the most awkward jobs as ideally one woud rempve the rear bench seat to give a bit more room to get at things Anyway, it doesn't answer the vexing 1.5'' or 2'' questiion.

Re: fuel filler for talari 216
 

We've had a few people inquire about replacing fuel caps so i'll have a look around the site to see if anyone has located a non-vented cap. In the meantime, my tape measure says 1.5"


added info: I think i gave you this one back in Aug 2012 - Attwood "Indy style" SS 1.5 fuel cap

there is also these from: Dana Marine