The Mariah Owners Club
Page 3 of 3 1 2 3
Show 40 post(s) from this thread on one page

The Mariah Owners Club (http://www.mariahownersclub.com/forum/)
-   Introductions (http://www.mariahownersclub.com/forum/introductions/)
-   -   Possible New Owner 94 Barchetta (http://www.mariahownersclub.com/forum/introductions/9526-possible-new-owner-94-barchetta.html)

mikeyt 06-30-2014 09:49 PM
Re: Possible New Owner 94 Barchetta
 
Quote:
Originally Posted by Bosgarage57 (Post 53712)
Thanks Mikey, the impeller doesn't seem hard, but you have to take the drive out right? It seems like a big job to do.

The issue with the trim is it wasn't trimming up enough, if the gauge isn't calibrated how are others able to trim effectively?

I was able to find the manual for the engine and drive thanks to the forum.
You dont need to take off the entire outdrive to replace the impeller, just the lower section.
Read my response in the other thread about the diffeence between the trim switch and the trailer switch.

Jimychanga 05-29-2019 02:52 PM
Re: Possible New Owner 94 Barchetta
 
Hi, did anyone here end up putting smart tabs on a barchetta? I have a 95 barchetta and would like to add tabs but am not sure if there is room, unless I can put them right next to the outdrive. Any insights appreciated!

mikeyt 05-30-2019 01:17 AM
Re: Possible New Owner 94 Barchetta
 
Quote:
Originally Posted by Jimychanga (Post 65682)
Hi, did anyone here end up putting smart tabs on a barchetta? I have a 95 barchetta and would like to add tabs but am not sure if there is room, unless I can put them right next to the outdrive. Any insights appreciated!
Read the "Smart Tabs" thread and all will be answered.


All times are GMT. The time now is 04:56 AM.
Page 3 of 3 1 2 3
Show 40 post(s) from this thread on one page