New to me 96 Talari 215
 

Long story short, I got a "free" boat! It had been sitting for 4 years and was no longer being used....ran when parked sorta deal. Anyways, I got it running this weekend, once insured and registered, we'll take it to the lake. If it gets around, then the project begins! Paint and gel coat a re rough, vinyl is super rough, the cuddy smells like a 70s camper. Any tips out there on these boats as I go from this first test on the lake and beyond?

Thanks,
Dan

Re: New to me 96 Talari 215
 

how long did you run it on muffs. change oil, drive oil, look for water in oil, fuel water separator, spark plugs and wires.dont be to adventurous on the first trip. but good luck and welcome

Re: New to me 96 Talari 215
 

as soon as you launch, check for leaks. check.
to make sure your charging, check for a cracked bellows

Re: New to me 96 Talari 215
 

Ran it till it came up to temp and I could verify no engine leaks, alternator was working, bilge pump, trim, fwd, reverse, out drive. Fuel tank is freshly siphoned, gas was def bad. I'll take her slow on the first go round, thanks for tips.

Re: New to me 96 Talari 215
 

Grease gimble bearing and motor coupler.

Sent from my SM-N975U using Tapatalk

Re: New to me 96 Talari 215
 

Added to the list, I didn't even know that there were grease fittings on there :eek_animated:

So gimble just uses same grease as a U-Joint I'm assuming?

Is there special grease for the coupler?

Re: New to me 96 Talari 215
 

Motor coupler uses EP grease due to high pressures between the steel drive shaft splines and the softer aluminum splines of the motor coupler. You don't want the coupler to fail, need to pull the engine to change it. I'm interested middle of that job now.
Gimbal bearing uses water proof trailer grease.

Sent from my SM-N975U using Tapatalk

Re: New to me 96 Talari 215
 

Use baking soda and a room deorderizor to get the smell out


Sent from my iPad using Tapatalk